A-Plus® Non-Sag Epoxy Adhesive & Putty

A-Plus® Non-Sag Epoxy Adhesive is a multi-purpose 2-component epoxy adhesive especially formulated for the demanding requirements of boat-building and repair. It is designed to have non-sag or non-drip properties, allowing you to apply on vertical or overhead substrates at a thickness of around 10cm. It bonds and cures to a very strong and very durable material resistant to seawater, chemicals, weathering, and mechanical abuse. It will even adhere and cure over damp surfaces.

• 100% Solids, Superior Strength, Durability, and Adhesion
• Specialized Non-Sag Epoxy Adhesive
• Achieve up to 10,000psi Compressive Strength(ASTM D695)
• Excellent Resistance to Water, UV, and Spillage of Chemicals and Oils
  
• Easily Sandable and Spreadable on Vertical or Overhead Applications
  
• Hardens, Toughens, and Improves Surface Against Mechanical Abuse and Impacts

SPECIFICATIONS:

Principal Uses: For use in a variety of marine and industrial construction works and repair: adhesive & sealer for wood and panel joints, putty for wood and metal substrates, bonding similar and dissimilar substrates(ex. metal on concrete), and many more.

Surface Dry: 1-2 hrs

Dry Through: Cures in 3 hours. Full strength within 3 days.

Coverage: Approximately 4sqm at 2mm thickness per gallon set

Thinning and Clean-Up: A-Plus® PG Epoxy Reducer

Application: Putty Knife/Spatula

Packaging: 250mL, 1L, 4L

Mixing Ratio: 1:1

Pot life: 45-90mins

Compressive Strength(ASTM D695): 10,000psi

Color: Part A – Off-White; Part B – Dark Beige

SURFACE PREPARATION AND PRECAUTIONS:

1. Surface must be thoroughly cleaned, free from any contaminants that may affect adhesion such as wax, oil, grease, rust and loose particles.
2. MIX WELL before using. Mixing ratio: 1:1 by volume, Component A and Component B.
3. Keep away from reach of children.
4. Avoid breathing vapor, use with adequate ventilation.
5. Avoid prolonged contact with skin. Wash hands thoroughly after handling, before eating or smoking.
6. All solvent-based and oil-based paints and putties are Flammable!

APPLICATION PROCEDURE:

1. Mix equal parts of components A and B thoroughly until a uniform color is achieved. Mix just enough amount that can be used within the pot life period.
2. Apply and spread the mixture over the prepared surface using a putty knife.
3. Allow to cure for at least 3 hours before sanding and filling.
4. Allow to cure for at least 3 days before subjecting to extreme conditions.
5. Use A-Plus® PG Epoxy Reducer to clean up excess material from equipment used while material has not yet hardened.